Water, Air, & Soil Pollution

Incorporation of Electrochemically Exfoliated Graphene Oxide and TiO 2 into Polyvinylidene Fluoride-Based Nanofiltration Membrane for Dye Rejection Abstract In this work, the novel direct synthesis method of dimethylacetamide-based graphene oxide (GO) was performed through electrochemical exfoliation assisted by commercially available single-tail sodium dodecyl sulphate (SDS) surfactant. Then, the synthesised GO (SDS–GO) was incorporated into polyvinylidene fluoride (PVDF) solution to produce a nanofiltration (NF) membrane through the phase immersion method. The addition of GO into the preparation of membrane solution alters the membrane morphology and improves the hydrophilicity. TiO2 was also used as an additive for the NF membrane fabrication to further increase the membrane hydrophilicity. The fabricated PVDF/SDS–GO/TiO2 and PVDF/SDS–GO NF membranes were compared with pure PVDF membrane. Then, the fabricated NF membranes were tested for methylene blue (MB) rejection with 10 ppm MB concentration. On the basis of the dead-end cell measurement operated at the pressure of 2 bar, the PVDF/SDS–GO/TiO2 presents high MB rejection (92.76%) and the highest dye flux (7.770 L/m2 h). This dye flux value was sevenfold higher than that of pure PVDF membrane (1.146 L/m2 h) which was due to the utilisation of both GO and TiO2 that improved the membrane hydrophilicity as indicated by the lowest contact angle (64.0 ± 0.11°). High porosity (57.46%) also resulted in the highest water permeability (4.187 L/m2 h bar) of the PVDF/SDS–GO/TiO2 NF membrane.

Short-Term Changes in Marine Prokaryotic and Eukaryotic Microalgal Communities Exposed to the Leachate of a Seafloor Hydrothermal Sulfide Abstract The effects of increased mining of seafloor massive sulfide deposits on marine ecosystems have not been characterized. In this study, the impact of leaching metals from a hydrothermal sulfide on photosynthetic protist and cyanobacterial communities in marine environments was investigated by amplicon analyses of small subunit rDNA (SSU rDNA) and rRNA (SSU rRNA). Seawater samples collected from the Iheya North region and Suruga Bay, Japan, were incubated with or without a leachate containing zinc, copper, cadmium, and manganese, of the actual seafloor hydrothermal sulfide from the Hakurei site in the Izena Hole region. The relative abundances of prasinophytes, diatom protists, and the cyanobacteria Synechococcus decreased substantially during incubation with leachate, indicating the vulnerability of these lineages to the leachate. Phylogenetic analysis based on the cyanobacterial phycocyanin cpcBA/rpcBA operon obtained from samples incubated with or without leachate indicated that the individual lineages of Synechococcus can determine sensitivity to heavy metals in different marine regions as well as particular clades and ecotypes.

Threats Underestimated in Freshwater Plastic Pollution: Mini-Review Abstract Plastic pollution is one of the most acute environmental topics of our time. While there is a great scientific effort to tackle this problem, it has not always been well-coordinated or properly targeted. In this short review, we call for scientists to get involved in three crucial topics (threats) underestimated—or ignored—in freshwater systems: (i) plastic-species entanglement, (ii) plastic as nesting material, and (iii) macroplastic debris coming from mismanaged household solid waste. Reducing the knowledge gaps between marine and freshwater environments will be crucial to solute the plastic pollution problem effectively and globally. Therefore, we make a plea here to reinforce research activities on these three issues in freshwater environments worldwide.

Impacts of Potassium Ferrate(VI) on the Growth, Protein, and Enzyme of the Microcystis aeruginosa Abstract As potassium ferrate(VI) is an important kind of water treatment agent which has a high efficiency in algal removal, its effects on the cell substance are rarely discussed. The changing of the protein and enzyme was analyzed here to deeply understand the oxidation of Fe on the protein in the algae. The result of the research showed the inactivation on growth and the biochemical process of the algal cell were all inhibited by Fe, including the function of the photosynthesis system. During the process, SOD (superoxide dismutase), CAT (catalase), POD (peroxidase), and GST (glutathione S-transferase) played cooperative roles to prevent the injury on the cells from destructive oxidation stress. The lipid peroxidation strengthened the defense system. The damage was intensified with the increase of ferrate concentration.

Modification of the Relative Abundance of Constituents Dissolved in Drinking Water Caused by Organic Pollution: a Case of the Toluca Valley, Mexico Abstract Drinking water contains geogenic elements to which human beings are exposed; in the long term, these elements can be either harmful (As) or beneficial (Mg and Ca) to health. The composition and relative abundance of the constituents in groundwaters are conditioned by the balance between dissolution, precipitation, and oxide-reduction processes also by the nature and spatial arrangement of the materials interacting with the water. In recent decades, human activities and changes in the use of land have led to the accumulation of organic materials and their degradation into nitrogen and phosphorus, which has resulted in a change of the physicochemical composition and quality of drinking water. The main target of the study was to evaluate the effect of contamination by nitrogen and phosphate organic matter on the physicochemical composition of water used for human consumption. The study was conducted in the Toluca Valley aquifer. The determination of parameters in situ and analysis in the laboratory of physicochemical parameters revealed the presence of NO3− (1.0–119 mg L−1), SO42− (6.81–24.70 mg L−1), PO43− (2.50–32.20 mg L−1), and N-NH4+ (0–5.40 mg L−1), which suggested the presence of punctual anthropogenic contamination; this was confirmed using 3D fluorescence to identify the presence of organic matter. The results of Na+(15.75 mg L−1), K+ (2.66 mg L−1), Ca2+ (8.73 mg L−1), and Mg2+ (8.01 mg L−1) using the ICP technique showed that the water supplied in the area has a low mineral content. Correlation between P and cations Ca2+ (0.844) > Na+(0.720) > Mg2+ (0.694) > K+ (0.60) indicates that anthropic contamination affects the relative abundance of dissolved constituents in water. The scarcity of essential nutrients in water impacts on public health; it has been reported that deficiency of Ca2+ and Mg2 implies a wide variety of clinical conditions, mainly in the development of cardiovascular diseases.

Occurrence and Environmental Distribution of 5 UV Filters During the Summer Season in Different Water Bodies Abstract Organic UV filters are used worldwide in various personal care products as well as textiles, paints, plastic, food, and adhesives. They are main ingredients in sunscreen lotions that are used heavily by beachgoers in the summer season. There is thus an increasing concern regarding the fate of organic UV filters in the environment and their impact on living organisms. Many of the UV filters in use are hydrophobic and are expected to accumulate in the sediment phase in aquatic systems, but this has yet to be validated in situ. We targeted the UV filters benzophenone 3 (BP3), butyl methoxydibenzoylmethane (BMDBM), diethylhexyl butamido triazone (DBT), bis-ethylhexyloxyphenol methoxyphenyl triazine (BEMT), and methylene bis-benzotriazolyl tetramethylbutylphenol (MBBT) in a freshwater lake and in a coastal bay in order to understand their distribution during summer 2016. Further, we examined their environmental partitioning by collecting samples from the surface water, the sediment phase, and water surface microlayer (SML). We show for the first time the presence of DBT, BEMT, and MBBT in environmental matrices (water, SML, and sediment). Notably, these UV filters were detected at low amounts in surface waters with maximum concentrations of 9.9 ng/L for DBT, 18.4 ng/L for BEMT, and below detection limits for MBBT and somewhat higher concentrations in the SML, with maximum concentrations of 43.3 ng/L for DBT, 5625.4 ng/L for BEMT, and 45.6 ng/L for MBBT. These filters were detected at even greater concentrations in the sediments, with maximum concentrations of 652.6 ng/g for DBT, 115.0 ng/g for BEMT, and 75.2 ng/g for MBBT (dry weight sediment). We also performed controlled laboratory experiments to determine their partitioning behavior, and we verified the actual solubility of many of the filters. This will help in determining the environmental fate and finally lead to a better risk assessment of these compounds. Together, these results corroborate the hypothesis that hydrophobic UV filters accumulate in the sediment phase and highlight the importance of discerning whether these UV filters impact the benthic community and their potential for bioaccumulation.

In Situ Synthesis and Photocatalytic Properties of Titanium Dioxide Nanoparticles on Cotton Fabrics Abstract In this paper, nanosized titanium dioxide as catalysts for degrading dye wastewater was in situ synthesized on the surface of cotton fabrics used tetrabutyl titanate as precursor. The morphology and structure of prepared catalysts were characterized by scanning electron microscopy, energy-dispersive spectrometer, and X-ray diffraction. The characterization results showed that anatase nanosized titanium dioxide was successfully synthesized in situ on cotton fabrics and had excellent dispersibility. Subsequently, the effects of irradiation time, catalyst dosage, dye concentration, initial pH value of dye, hydrogen peroxide dosage, and dye type on dye degradation rate were investigated one by one by a photocatalytic performance test. The test results indicated that the degradation rates of methylene blue, methyl orange, and rhodamine B were 90.4%, 81.4%, and 58.3%, separately, at catalyst dosage of 4.8 g/L, initial dye concentration of 10 mg/L, pH of 7, and hydrogen peroxide dosage of 0.24 mol/L, after 4 h of UV irradiation.

Phytoplankton Cultures for Tannin Biodegradation Abstract Tannins are special plant metabolites used in leather processing that act as pollutants. These substances are toxic to aquatic biota and can cause cell rupture. These harmful effects make the treatment of tannery wastewater difficult. Phytoplankton species are community components that are rarely considered in the biodegradation of organic compounds. However, in association with bacteria, these organisms can improve the biodegradation of pollutants by different mechanisms. The aim of the present study was to evaluate the potential of non-axenic cultures of Chlorella vulgaris containing Lactobacillus casei and Synechococcus sp. containing Rhizobium rosettiformans and Sphingomonas koreensis to biodegrade tannic acid (TA). Cultures in BG-11 medium containing TA (250 mg L−1) were incubated under a photoperiod or in the dark and monitored for 96 h. The cultures with added TA grew more than the control cultures under both the photoperiod and dark conditions. A reduction in the TA concentration and the TA metabolite gallic acid was observed under both conditions. Ellagic acid was identified and demonstrated resistance to biodegradation under the evaluated conditions, and neither of the other metabolites was detected. BG-11 culture medium is poor in organic material; therefore, microalgae and cyanobacteria contribute to bacterial metabolism. Under experimental conditions, phytoplankton species seem to contribute to the biodegradation of tannin residues, and in natural environments, they may aid in the bioremediation of sites contaminated by these pollutants.

Assessment of Heavy Metal Sources in Soils from a Uranium-Phosphate Deposit Using Multivariate and Geostatistical Techniques Abstract The quantification of heavy metal contents in soils and their sources are essential for contamination monitoring and the assessment of the potential risks to the ecosystems. This study aims to investigate the source of heavy metals and other elements in soils from a uranium-phosphate deposit using integrated multivariate and geostatistics techniques. For this, 50 soil samples in Itataia deposit, Northeastern, Brazil, were collected at 0–0.2-m depth for the determination of U, Fe, Al, Mn, Ti, Zn, Cu, Ni, Mo, Co, Cr, Cd, Pb, As, Se, V, B, and Zr. The Pb, Se, Ni, Cr, As, and Mo mean contents were closer or exceeded The Brazilian Environmental Council (CONAMA) prevention values for soils. Uranium content was about 500 times higher than the mean levels reported for Brazilian soils. The cluster analysis indicates three geochemical groups based on different contamination levels. The first principal component was associated with lithological origin, the second principal component may be related to anthropogenic sources, and the third and fourth principal components indicated a joined source (natural and anthropogenic), indicating different sources of contamination. Mo was not related to other heavy metals, being found independent in the area. The accumulation of heavy metals in soils is associated not only with the parent material but also with the minerals of the soil. In the area of study, calcareous soils favored alkaline conditions that influenced the dynamics of heavy metals. The multivariate and geostatistical analyses were able to provide preliminary information regarding the metal contents in soil for environmental management.

Toxicity Study of a Textile Effluent Treated with Electrohydraulic Discharge and Coagulant/Flocculants Abstract Exposure to complex organic substances present in textile wastewater has been considered a threat to human health and aquatic organisms. Development of appropriate treatment mechanisms, as well as sensitive monitoring assays, is considered important in order to safeguard and protect the delicate natural equilibrium in the environment. In this study, combined coagulation/flocculation and electrohydraulic discharge (EHD) system were explored for treatment of textile wastewater. Pre- and post-treatment samples were used to evaluate process efficiencies. Process efficiencies were evaluated using physicochemical characteristics, and cytotoxicity and inflammatory activities induced in macrophage RAW264.7 cell line. The RAW264.7 cell line was evaluated as an alternative to animals and human blood culture models, whose routine applications are hindered by stern ethical requirements. The toxicity of effluent was evaluated using WST-1 assay. The inflammatory activities were evaluated in RAW264.7 cell culture supernatant using nitric oxide (NO) and interleukin 6 (IL-6) as biomarkers of inflammation. The levels of NO and IL-6 were determined using the Griess reaction assay and double-antibody sandwich enzyme-linked immunoassay (DAS ELISA), respectively. Overall, the results of this study show that combined approaches and not the single EHD system are sufficient for complete removal of chemical oxygen demand (COD) and total organic carbon (TOC), toxicity and inflammatory activities in textile wastewater. The study shows that induction of NO and IL-6 secretions in macrophage RAW264.7 cells is a very sensitive model system to monitor the efficiency of textile effluent treatment processes.